User's Manual

Fig.28
Fig.27
Coding Transmitters
Step 13.3 - Setting the Transmitter to Operate
Vacation Mode (Fig.27)
The operator can be programmed into a “Vacation Mode”
where the opener will not respond to any transmitter except
one preprogrammed unit.
Press a. DOOR CODE button three times. The DOOR
CODE LED will illuminate and the courtesy light will
ash slowly (once every two seconds) to indicate
Vacation learning mode is active.
Choose a transmitter button not already coded into the b.
receiver. Press this button and the DOOR CODE LED
will begin to ash.
Press the same transmitter button again. The DOOR c.
CODE LED will illuminate for one second and then go
out, and the courtesy light will also switch off. This
indicates the code has been stored.
To activate Vacation Mode, close the garage door and d.
press the coded button transmitter for 5 seconds. The
DOOR CODE LED will illuminate to indicate that the
opener is in Vacation Mode.
To exit Vacation Mode press the transmitter button e.
momentarily until the DOOR CODE LED turns off.
Step 13.4 - Setting the Transmitter to Operate the
Auxiliary Output (Fig.28)
It is possible to operate other devices (e.g. alarm systems)
using one of the spare buttons of a multi-channel transmitter
coded into the Auxiliary Output feature.
Press the a. DOOR CODE button four times. The DOOR
CODE LED will illuminate and the courtesy light will
ash quickly (twice per second) to indicate that
learning mode for the Auxiliary Output is active.
Choose a transmitter button not already coded into the b.
receiver. Press this button and the DOOR CODE LED
will begin to ash.
Press the same transmitter button again. The DOOR c.
CODE LED will illuminate for one second and then go
out, and the courtesy light will also switch off. This
indicates the code has been stored.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encourage to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna•
Increase the separation between the equipment and receiver•
Connect the equipment into an outlet on a circuit different from that to which the receiver is •
connected
Consult your local dealer or an experienced radio/TV technician for help.•
Select one of the four buttons
D Power Drive : Instruction Manual
© Copyright 2011
19PA800V1 Instruction Manual (Instructions d’installation)