User's Manual

ManualsBrandsAutomatic Technology ManualsElectronicsPTX-5V1 REMOTE CONTROL TRANSMITTER

Coding Transmitters

Fig.25

Fig.26

Step 13.1 - Coding a Transmitter Button for Door

Operation (Fig.25)

The operator can only operate from transmitters that have

been programmed into its receiver. The receiver needs to

learn the codes of any transmitter that will be used with the

operator. Up to eight (8) codes can be stored in the receiver’s

memory.

Press and release the a. DOOR CODE button. The

DOOR CODE LED will illuminate to indicate the

opener is in Code Learn mode. If a valid code is

not stored within 15 seconds the operator will exit

Code Learn.

Press one of the four buttons on the transmitter. The b.

DOOR CODE LED will begin to ash.

Press the same transmitter button again. The DOOR c.

CODE LED will illuminate for one second and then go

out.

The transmitter is now coded to operate the door. Press d.

that button to test again.

Step 13.2 - Setting the Transmitter to Operate the

Courtesy Light (Fig.26)

Although the courtesy light comes on with each operation of

the opener, it may also be controlled by a transmitter without

operating the door.

Press the a. DOOR CODE button twice. The DOOR CODE

LED will illuminate and the courtesy light will turn on to

indicate that the light code learning is active.

Choose a transmitter button not already coded into the b.

receiver. Press this button and the DOOR CODE LED

will begin to ash.

Press the same transmitter button again. The DOOR c.

CODE LED will illuminate for one second and then go

out.

The transmitter is now coded to operate the light. Press d.

that button to test again.

Transmitters Compliance Statement

Transmitters comply with all United States and Canadian legal requirements as of the date

of manufacture. To comply with FCC Part 15 and or RSS 210 of Industry Canada (IC) rules,

adjustment or modications of this receiver and / or transmitter are prohibited, except for

changing the code setting or replacing the battery. THERE ARE NO OTHER USER SERVICEABLE

PARTS. Tested to Comply with FCC Standard FOR HOME OR OFFICE USE. Operation is subject

to the following two conditions:

(1) this device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that may cause

undesired operation.

Select one of the four buttons

PA800V1 Instruction Manual (Instructions d’installation)18