User's Manual

Setting Safety Obstruction Force
Adjusting Safety Obstruction Force
The safety obstruction force is calculated automatically
and normally does not require adjustment. The only time
the force may need to be adjusted is due to environmental
conditions, such as areas that are windy, dusty or have
extreme temperature changes that affect the operability
and movement of the door.
Step 12.3 - To Increase Force Pressure (Fig.22)
Press and hold the FORCE MARGIN SET button.a.
While holding down the FORCE MARGIN SET button, b.
press the PLUS (+) button. Each press will increase
the force margin one step.
The OPEN LIMIT LED will ash each time the PLUS c.
(+) button is pressed to indicate an increase in force.
If the OPEN LIMIT LED ashes continuously when the d.
PLUS (+) button is being pressed, this indicates that
the maximum force setting has been reached.
Test the force again as per e. Steps 12.1 and 12.2.
Step 12.4 - To Decrease Force Pressure (Fig.23)
Press and hold the FORCE MARGIN SET button.a.
While holding down the FORCE MARGIN SET button, b.
press the MINUS (-) button. Each press will decrease
the force margin one step.
The CLOSE LIMIT LED will ash each time the MINUS c.
(-) button is pressed to indicate a decrease in force.
If the CLOSE LIMIT LED ashes continuously when d.
the MINUS (-) button is being pressed, this indicates
that the minimum force setting has been reached.
Test the force again as per e. Steps 12.1 and 12.2.
Step 12.5 - To Recall Factory Set Force
While holding down the FORCE MARGIN SET button a.
press the SET button for two seconds (Fig 24).
Release both buttons. The default setting should now b.
be recalled.
WARNING: Safety Beam must be installed if
the closing force as measured at the bottom
edge of the door exceed 200N (20kg).
Fig.22
Fig.24
Fig.23
D Power Drive : Instruction Manual
© Copyright 2011
17PA800V1 Instruction Manual (Instructions d’installation)