User's Manual

PA800V1
120Vac/60Hz
165W
Programming The Opener
Step 11.1 - Setting Limits Positions
Remove the controls cover to access the controls panel as
shown in (Fig.17). Replace it when setup is completed.
Step 11.2 - Connect Power to the Powerhead
Plug the power cord into a mains point and switch power
on. The red CLOSE LIMIT LED will be ashing.
Step 11.3 - Set the Datum Position
Press and hold the MINUS (-) or PLUS (+) buttons to a.
move the door to the halfway position. Ensure that the
door, shuttle and chain index are engaged.
Using a small screwdriver, turn the DATUM ADJUST b.
screw until the STATUS LED comes on (Fig.18).
Step 11.4 - Set the Limits Positions
Press and hold the MINUS (-) button until the door a.
reaches the desired close limit position. Single presses
will inch the door closed (Fig.19).
Press the SET button to store the close position into b.
memory (Fig.19).
Press and hold the PLUS (+) button until the door c.
reaches the desired open limit position. Single presses
will inch the door open (Fig.19).
Press the SET button to store the open position into d.
memory (Fig.19).
Fig.19
Fig.18
Fig.17
IMPORTANT NOTE: The OPERATE button
will not function until the open and close
limit positions are set.
NOTE: The Safety Beam must be installed
before setting the travel limits.
NOTE: The door and shuttle must be
engaged into the chain index. The door
should be open approximately half way.
WARNING: The safety obstruction detection
system is inoperable while MINUS (-) and
PLUS (+) drive buttons are being used and
travel limits are not set.
WARNING: The door will automatically close,
open and close again once Step 11.4(d) is
performed. Ensure that no persons or objects
are in the door’s path.
The door will now automatically close and open to e.
calculate the safety obstruction settings. After this, the
opener can be operated with the OPERATE button.
NOTE: If the STATUS LED is already illuminated when the
door is halfway up, turn the DATUM ADJUST screw until
the light goes off, then turn back one notch to illuminate
again.
Via Control Panel
D Power Drive : Instruction Manual
© Copyright 2011
15PA800V1 Instruction Manual (Instructions d’installation)