User's Manual

How To Use Your Operator
Safety Beam
A Safety Beam Kit must be tted to this operator.
When this Kit is tted, the operation of this device is •
such that if an object (i.e. car, child, etc.) blocks the
Safety Beam, then the garage door operator will not
close the door automatically.
When the Safety Beam is tted but not operating •
correctly, then the door once opened automatically,
will not close automatically. The door may be closed
by reverting to manual operation – see Manual
Operation.
Courtesy Light
The Courtesy Light will illuminate for approximately three
(3) minutes each time the door is operated automatically.
Spare buttons of a multi-channel transmitters can be
programmed to turn the light on and off by remote control.
See Step 13.2 for more information.
Auxiliary (AUX) / Operate (OSC) Output
The Auxiliary Output allows the opener to operate other
devices such as another opener or an alarm system.
To use this function, a spare button of a multi-channel
transmitter must be programmed to operate the Auxiliary
Output feature.
See Step 13.4 for more information.
The Operate (OSC) function allows the operator to open/
stop/close the door. Connect a normally open switch to this
input for operation.
Vacation Mode
The radio receiver of the garage door operator can be
turned off to all but one transmitter via Vacation Mode.
Whilst in vacation mode the operator will not respond to
any transmitter.
To activate the Vacation Mode facility, see Step 13.3.
NOTE: program only one button to control “Vacation Mode”.
This will reduce the possibility of accidental activation of
this feature.
Pet (Pedestrian) Mode
A transmitter can be programmed to open the door partially
to allow pet access to the garage.
To activate Pet Mode press the transmitter button that
has been programmed for Pet Mode - The door will open
partially.
See Step 13.5 for more information.
PA700V1 Instruction Manual (Instructions d’installation)24