Owner's Manual

Mounting the Hub
a. Determine whether you are going to wall mount the hub.
ii. If hub is to be placed on bench, simply connect to power
supply, turn on and proceed to installing the Transceiver.
iii. If hub is to be wall mounted follow steps below.
d. To wall mount - Use wall bracket
3
as template to mark
where to drill holes. Pre-drill holes.
i. For plaster walls - insert (2) two Plastic wall plugs into holes,
place wall bracket over holes and affix with (2) two self
tapping screws
5
.
ii. For brick walls - place wall bracket
3
over holes and affix
with (2) two self tapping screws
5
.
c. Slide the hub
1
over the bracket.
d. Connect the power supply and turn on.
1
3
5
This device must be connected to power at all
times. DO NOT disconnect power after setup.
Before going out to site, check the following with the customer:
a. The customer has a Smart Phone: Android (running 4.4 and above) or IPhone (running iOS8 and above)
b. An internet connection for remote operation is available.
c. A 2.4ghz WiFi network is set up.
d. We recommend the customer has a WPA2 encryption on the WiFi network as other network types are not as secure.
Installation
Important Safety Instructions
WARNING!
• DO NOT attempt to disassemble, repair or modify the product. This will invalidate the
warranty.
• Do not allow children to play with the Base Station or your smart phone if the ATA phone
app has been installed.
ELECTROCUTION!
• Keep the device away from water and other liquids. In the event that water or other liquids
enter the device, power off he product immediately and clean the device.
• To reduce the risk of fire or electric shock, do not expose this device to rain or moisture. The
device should not be exposed to dripping or splashing.
• DO NOT remove the cover as there are no user-serviceable parts inside.
CAUTION:
Fall from ladder • Ensure ladder is the correct type for job.
• Ensure ladder is on flat ground.
• Ensure user has 3 points of contact while on ladder.