Owner's Manual

Roller Door Opener Set Up
Preparation of Opener
a. Disconnect the power supply to the opener.
b. Remove the light diffuser via screw at the bottom.
c. Remove the grommet out of the back cover.
d. Cut (1) one side of the grommet with a knife or scissors.
e. Slide the network timing harness
2
into the cut in the
grommet.
f. Refit grommet to back cover by sliding the harness
through hole before fitting grommet.
g. Connect the harness to the network pin on the control
board.
h. Refit the light diffuser.
Mount and connect Transceiver
a. Plug the other end of the harness into the transceiver
1
.
b. Place the transceiver
1
on the side of the opener to
the black, back cover so that the screw holes on the
transceiver line up with those on the back cover.
c. Secure transceiver using the (2) two Taptite M4 x 12
screws
3
or velcro
4
.
Re-setup and Test the Opener
a. Reconnect power and remove the button cover.
b. Setting Limits:
i. If limits have not been set, follow the openers
installation sheet to set limits.
ii. If limits were set previously, clear limits and follow
openers installation sheet to set limits.
c. Refer to the Smart Phone Control Kit User Guide to set up
network capabilities.
2
1
1
Network Pin
Light diffuser
Grommet
Light diffuser
screw
Aerial slot
Affix with screw here
Preparation of Opener
a. Disconnect the power supply to the opener.
b. Open the side cover on the right hand side (looking from
back of unit).
c. Connect the harness
2
to the network / programmer pin on
the control board.
d. Place the transceiver
1
inside the cover, threading the aerial
through the slot provided and affix with one (1) Taptite Screw
3
.
e. Refit the side cover.
Re-setup and Test the Opener
a. Reconnect power and remove the button cover.
b. Setting Limits:
i. If limits have not been set, follow the openers installation
sheet to set limits.
ii. If limits were set previously, clear limits and follow operators
installation manual to set limits.
c. Refer to the Smart Phone Control Kit Quick Set Up Guide to
set up network capabilities.
1
3
2
NOT available with AM-800
(optional for AM-808)
Sectional Door Opener Set Up