Installation Instructions

Auto-Lock Installation Instructions
6
LED status
lock position status
The status normally displays for 10secs
after lock movement / button press.
LED STATUS INDICATORS
RED GREEN LOCK STATUS
FLASHING RAPIDLY LOCKING
ON LOCKED
FLASHING RAPIDLY UNLOCKING
ON UNLOCKED
ON ON ERROR
FLASHING SLOWLY FLASHING SLOWLY LOW BATTERY
FLASHING
ALTERNATIVELY
FLASHING
ALTERNATIVELY
NO LINK WITH
BASESTATION
troubleshooting
problem cause remedy
door not moving communication failure switch off power to opener, the switch back on after 30
secs (If a battery backup is installed press & hold STOP/
SET button on the opener until power ceases). Press the
lock/ unlock button on the lock to test operation.
Press the (i) button on the lock & refer to the LED status
table above.
main light flashes 3 times
on the opener
low battery indicator replace the batteries as per instructions below.
door not moving and no
lights on lock
limited battery power press the (i) button on the lock to see if there is power
in the battery.
no lights - change battery
lights - check LED status table.
main light flashing 5 times
on the opener
lock is not unlocked and preventing
the door moving
check lock, test by pressing emergency release button
on the lock and then test door operation.
lock is not unlocking
and preventing doors
movement
lock jammed
door wheel is pushing on the lock
barrel.
remove the lock drive unit from the locking mechanism
and test the manual operation of the bolt by engageing
and disengaging the lock manually.
check the lock barrel is not catching on the track.
red and green lights both
on solid on the lock.
error with lock press the unlock button on the lock to test operation.
switch off power to opener, then switch back on after 30
secs (If a battery backup is installed press & hold STOP/
SET button on the opener until power ceases). Press the
lock/ unlock button on the lock to test operation. If it
does not move contact your installer.
red and green lights on
one lock flashing slowly
low battery change battery, then test operation of lock by pressing
the lock / unlock button.
red and green lights
flashing alternatively
no link to opener press the unlock button on the lock with flashing lights
to disengage the bolt. Call your installer for assitance.