Troubleshooting guide

GDO-9v2 SecuraLift

Owner Installation Instructions

C-Rail Attachment

ﬁ g

Locate shaft into sprocket

Shaft

Hex ﬂ ange screw taptite ‘S’ M4 x 10

Track bracket (x2)

Step 2 - Attach Manual Disengage Cord

If not already disengaged, ﬂ ick the yellow clutch

lever up so it sits perpendicular to the rail.

Thread the loose end of the cord through the hole

in the yellow clutch lever (Fig. 05).

Thread the cord down to red toggle and knot

through the spare hole.

Test if secured properly by pulling back towards

sprocket end to engage, and the towards door end

to disengage.

Step 3 - Secure C-Rail to Drive Unit

Locate and insert the shaft of drive unit into the C-

Rail’s sprocket (Fig. 06).

Fix the two track brackets with four screws supplied

in accessory pack (Fig. 07).

ﬁ g