Installation manual

FEATURES
- 4 -
©Copyright 2006 Automatic Technology
Thank you for purchasing the ATA
SecuraLift
®
Automatic Garage Door
Opener. This opener is designed to
suit sectional overhead and one
piece tilt up doors. The components
and materials used in this opener
are of the latest technology and
highest quality. Listed below are
some of the many features.
OPERATION
To open or close the door simply
press the hand held transmitter, the
wall mounted transmitter, or optional
wall switch for two seconds. During
an open or close cycle the door can
be stopped by pressing the button
while the door is in motion. The next
actuation will move the door in the
opposite direction.
HOPPING CODE
Every time a transmission is made
from the remote transmitter a new
security code is generated. The
number of possible code
combinations is over 4.29 billion.
This greatly enhances the security
of the system. Code “grabbing” is
made a thing of the past.
S-ALPS (SEMI AUTOMATIC
LIMITS POSITIONING SYSTEM)
The ALPS system does away with
manual adjustment of the doors’
limits position using mechanical
parts, such as cams and micro
switches.
During installation the hand held
transmitter can be programmed to
set the door limits positions.
ANTI TRAVEL ELECTRONIC
BRAKES
opener has anti travel electronic
brake mechanism which ensure the
opener stops the door at exact
location
ISS (INTELLIGENT SAFETY
OBSTRUCTION SYSTEM)
While the door is performing a close
cycle, should it hit an obstacle or be
restricted in some manner, it will
automatically reverse. The amount
of force the door should encounter
before reversing is automatically
adjusted by the doors control
system during the initial installation
of the automatic door opener. The
door will also stop if restricted whilst
opening. The Safety Obstruction
Force should be checked at least
once a month. See installation
manual for instructions.
SECURITY CODE STORE
The SecuraLift
®
Garage Door
Opener uses state of the art
technology in storing your selected
transmitter security code. Up to 24
different transmitters can be stored
in the openers memory.
OVER LOAD INDICATOR
When the maximum opening and
closing capacity of the opener is
exceeded the red and green Limits
LEDs flash alternately to indicate
that an overload has occurred.
AUTO COURTESY LIGHT
The courtesy light on the opener
comes on automatically whenever
the door is activated. The light can
also be switched on and off without
operating the door. This is done by
pressing the button on any hand
held or wall mounted transmitter
which has been stored with the light
code.The light will stay on for
approximately three minutes then
switch off. This time is also
adjustable.
ANTI VIBRATION BRACKETS
opener has inbuilt antivibration
brackets
hang the opener by using anti vibra-
tion brackets where noise is the
problem
VACATION MODE
A hand held transmitter can be
programmed to lock and unlock all
other transmitters that have been
programmed into the openers’
memory. The vacation mode can be
used when the door is left idle for
long periods of time.
PET (PEDESTRIAN) MODE
The hand held transmitter can be
programmed to open the door
partially so that the family pet can
enter and exit the garage at any
time. You may also wish to open the
door to a height suitable only for
pedestrian access. The door open-
ing position is also programmable.
AUTO CLOSE MODE
The opener can be programmed to
automatically close after an open
cycle. The auto close time is
adjustable. It is compulsory to install
a Photo Electric Beam if this mode
is selected, otherwise the door may
cause personal injury or damage to
property.
PHOTO ELECTRIC BEAM
(OPTIONAL)
The opener has an input for a photo
electric beam to be connected for
extra safety protection and use of
the auto close mode.
MANUAL OPERATION
The opener is equipped with a
unique manual disengaging device.
If the power to the opener is
disrupted for any reason the door
can be put into manual mode by
pulling down on the string handle on
an angle towards the door. This will
allow you to manually open or close
the door. To re-engage the opener
pull the string handle away from the
door.