Installation manual

BATTERY BACKUP INSTALLATION
ORDER CODEQTYDESCRIPTIONITEM
1BATTERIES SUPPORT9
HEXAGON STANDOFF M410 2
BATTERY HARNESS
BATTERIES COVER
BATTERY COUPLING WIRE - ESV24
SBY-3 VERSION 1.00
SBY-3 ESV24 CHARGER HARNESS
SBY-2 BATTERY HARNESS
BATTERIES 12V SEC12-2.2 AGM TYPE
PAN HEAD SCREW W'WASHER M4x8
8
7
5
6
2
3
4
1
1
1
2
1
1
7
1
1
16480
11190
12005
15670
15470
16460
14115
10320
15660
00852
PARTS LIST
2. CONNECT WIRES AS SHOWN
4. CONNECT
1. REMOVE SCREWS &
SWING COVER TO OPEN
3. MOUNT BATTERY AND SECURE
WITH ITEM 4 & 10
5. CLOSE COVER AND
RE-SECURE WITH SCREW
REFER TO WIRING DIAGRAM
WIRING DIAGRAM
BATTERY ASSEMBLY (#01660)
22
BATTERY BACK UP (OPTIONAL)
The opener has provision to include a battery back up
module. This is an ideal addition if the garage door is the
only entrance to the garage or if the area is prone to
power cuts.
INSTALLATION
1. Disconnect power to the opener .
2. Remove screws and swing the cover to open fig 42.
3. mount battery pack and secure with item 4 and 10.
4. Mount the Charger Board SBY-3 on three hex spacers
pre mounted on base and
secure with three (3) M4 x 8 screws.
5. Feed 2-Wire battery Harness , through the grummet on
the base plate and connect to sby-3
6. Feed charger harness from sby-3 to control board and
plug 4 pin connector marked sby-3 on the control board
Warning: After Step 7 the opener may become active
(even when power is off). This is a result of a residual
charge in the batteries.
This will only occur if batteries still hold some charge.
7. Connect battery harnesses item 3 and 7 together
(Fig. 42).
8. Reconnect power
FIG. 42
TESTING BATTERY BACK UP
1. Press either operate button or transmitter
to test the opener.
2. Whilst door is in motion disconnect mains power
The door should continue to operate as normal.
Note: Wait for the door to complete its travel.
3. Press operate or transmitter to activate the door.
4. Whilst door is in motion re-connect power. The door
should complete the cycle as normal.
TROUBLE SHOOTING
If door stops or moves very slowly under battery power:
- Batteries may be weak or have no charge
- connect power and allow to charge.
- Batteries may take 24 - 48 hours to reach maximum
charge capacity.