Installation manual

ManualsBrandsAutomatic Technology ManualsGarage Door OpenerGDO-8V2 EasyRoller II

GDO-8V2 EasyRoller® II Owner Installation Instructions

Door Status Indicators

Symptom Possible cause Remedy

Door will not operate Mains power not switched on.

Door is obstructed.

Door is locked or motor jammed.

Door tracks/hardware damaged.

Switch on mains power.

Remove obstruction.

Unlock door or remove jam.

Door requires service/repair by

qualiﬁ ed technician.

Door starts to close but

automatically reverses to

open position

Adverse weather conditions (wind

or cold) causing door to stiffen and

become tight in the tracks.

Possible obstruction in the

doorway.

Increase force margin setting

See Step 8.3 on page 13. Or re-

calculate force margin.

Remove obstruction.

Door operates from drive unit

(OPERATE) button but not from

transmitter*

See note

Transmitter code not stored in

memory.

Flat battery.

Code transmitter in to openers

memory. Refer step 9.1 on page

Replace battery - A23 Alkaline 12V.

Door will not open or close fully. Door limits position need to be

reset.

Door limits position need to be

reset. See Page 14.

Door is overshooting or not

reaching limits.

Datum position not set correctly. Reset datum position. See Step 6.2

Page 13

Cannot set limits. Datum position not set correctly. Reset datum position. See Step 6.2

Page 13

Door not working with PE installed. PE Beam or wiring faulty.

PE Beam not aligned correctly.

PE Beam is obstructed.

Door obstructed when closing.

Repair PE Beam or replace wiring.

Re-align optics. See PE

Instructions.

Remove obstruction from the path

of PE.

Remove obstruction.

PLEASE NOTE:

Some areas may be prone to excessive radio interference brought on by devices such as cordless telephones,

wireless stereo headphones and baby monitors. It is possible that these devices could cause a degree of

interference such as to greatly reduce the range of the transmitter. In such an instance please contact your

Automatic Technology dealer for an alternative frequency replacement kit. As this is not a warrantable situation

but an environmental issue charges may apply for the changeover.

Trouble shooting