Installation manual

Owner Installation Instructions GDO-8V2 EasyRoller® II 19
Default settings & specifi cations
Factory Default Settings
Default Step Maximum
Maximum motor run time 30 seconds - -
Obstruction force margin 8 1 -
Technical Specifi cations
Input: 230v. - 240v AC 50Hz
230V OR 115V 50 - 60 Hz ( Only In DSV Model )
Controller voltage: 24v. DC
Standby power: 2.8W
Motor power: 100W
Operating temperature +5° to +40°C
Maximum door opening:
1,2
width:
height:
weight:
5500mm
2700mm
100kg
Maximum lifting force: 450N (45kg)
Recommended lifting force: 120N (12kg)
Opener limits travel: 3.25 Turns of door drum wheel
Operating time - intermittent: 4 minutes
Reciever type: UHF 433.92 MHz. am receiver
Receiver code storage capacity: 8 x 4 button transmitter codes
Transmitter frequency: 433.92 MHz
Coding type: Code hopping
No. of code combinations: Over 4.29 billion random codes
Code generation: Non-linear encryption algorithm
PTX-4 transmitter battery: A23 Alkaline 12V
NOTE:
1. The maximum continuos curtain residential roll up door opening that the EasyRoller® can be installed on is
5500mm wide by 2700mm high. The door must be well balanced. A person of average strength should be able
to lift up the door manually with very little effort in case of an emergency.
2. Intermittent operations may occur in areas which experience very strong winds. The strong wind puts extra
pressure on the door and tracks which may in turn trigger the safety obstruction detection system intermittently.