Installation manual

Owner Installation Instructions GDO-10V1 Toro
®
7
SmartSolar™ Compatibility (optional)
The opener can be fi tted with a SmartSolar™ kit (Part Number 00142) for operation,
where mains power access is not available. NOTE: If the door is the only entrance
to the garage, a keyed cable release should be fi tted external to the garage.
Vacation Mode
A hand held transmitter can be programmed to lock and unlock all other
transmitters that have been programmed into the openers’ memory. The vacation
mode can be used when the door is left idle for long periods of time.
Pet/Pedestrian Mode
The transmitter can be programmed to open the door to an adjustable partial height
so that the family pet can enter and exit the garage at any time. You may also wish to
open the door to a height suitable only for pedestrian access.
Auto-Close Mode
The opener can be programmed to automatically close after an open cycle. The auto-close
time is adjustable. It is compulsory to install a PE Beams. if this mode is selected, otherwise
the door may cause personal injury or damage to property.
Photo Electric (PE) Beams
The opener has an input to connect a PE Beams for extra safety and use of the auto-close mode.
Manual Operation
The opener is equipped with a unique patented manual disengaging device. If the power to the opener is
disrupted for any reason the door can be put into manual mode by pulling down on the string handle, then
releasing. This will allow you to manually open or close the door. When power is restored, by pulling down
on the string handle and releasing, the opener is put back into automatic mode.