Installation manual

Owner Installation Instructions GDO-10V1 Toro
®
5
The garage door must be well balanced. Sticking or binding doors must be repaired by a qualifi ed garage door
installer prior to installation of the opener.
Frequently examine the installation, in particular cables, springs and mountings for signs of wear, damage or
imbalance. DO NOT use if repair or adjustment is needed since a fault in the installation or an incorrectly
balanced door may cause injury. DO NOT attempt to repair the door yourself as hardware is under extreme
tension.
Remove or disengage all garage door locks and mechanisms prior to installation of the opener.
Connect the opener to a properly earthed general purpose 240V mains power outlet installed by
a qualifi ed electrical contractor.
Disconnect the power cord from mains power and Back Up batteries before making any
repairs or removing covers. Only experienced service personnel should remove covers from
the opener.
When using auto-close mode, a photo electric beam must be fi tted correctly and
tested for operation at regular intervals. Extreme caution is recommended when
using auto-close mode. All safety rules must be followed.
In order for the opener to sense an object obstructing the door way, some force
must be exerted on the object. As a result the object, door and/or person may
suffer damage or injury.
If the power supply cord is damaged, it must be replaced by an Automatic
Technology service agent or suitably qualifi ed person.
Make sure that the door is fully open before driving in or out of the
garage and fully closed before leaving the driveway.
Make sure that remote controls are kept out of reach of children.
Install the wall control unit or wall mounted transmitter in a
location where it is out of reach of children and the garage
door is visible.
Important Safety Instructions