Installation manual

Owner Installation Instructions GDO-10V1 Toro

Technical Speciﬁ cations

Power supply 230V - 240Va.c. 50Hz

Standby power 2.6 Watts

Geared Motor power 150 Watts

Motor type 24Vd.c. Permanent Magnet

Maximum door opening: Height:

Width:

Weight:

5500mm

5100mm

270kg

Opener Limits Travel 5.5 turns of Door Drum Wheel

Maximum Rated Load 500N

Nominal Load 150N

Duty Cycle 25 Operations/hr

Receiver type UHF Multi-frequency FM Receiver

Receiver code storage capacity 511 X 4 button Transmitter Codes

Receiver Sensitivity – 103 dB

Transmitter frequency UHF Multi-frequency FM Transmitter

Coding type Code hopping

Number of code combinations Over 4.29 billion random codes

Code generation Non-linear encryption algorithm

Courtesy light Relay Output

Lock Output Relay Output

Controller fuse 10 A slow blow

Transmitter Battery CR - 2032 (3 Volts)

Real Time Clock Battery CR -1220 (1.5 Volts)

Back Up Battery 12 Volts 6 Amp Hr x 2

NOTE:

1. The door must be well balanced. A person should be able to lift the door up manually with very little effort in

case of an emergency.

2. Intermittent operations may occur in areas which experience very strong winds. Strong wind puts extra pressure

on the door and tracks which may in turn trigger the safety obstruction detection system intermittently.

3. If the PE beams are not installed then the controller will automatically goes into “ safety close “ mode . Limited

number of features are available in this mode see page 30.

Speciﬁ cations