Installation manual

Owner Installation Instructions GDO-10V1 Toro

Step 16 - Setting Up Auto-Close Mode

IMPORTANT NOTICE: the Auto-Close function is not available unless PE Beams are installed.

Auto-close mode is a function that automatically closes the door a preset time after the PE Beams recognise

that a vehicle has left the garage.

The Auto-close timer only starts after the PE Beams path is broken the Auto-close timer has been set. If the

PE Beams path is not broken the door will remain open until the path is broken. If the opener incurs a physical

obstruction (i.e. not from the PE Beams) while closing the door will re-open and not Auto-close until the PE

Beams path is broken again.

Menu 3. Auto-Close Times

The auto-close modes automatically closes the door after it has been operated. To implement this, the

controller starts a timer once the door has reached its desired open position. The timer then counts down and

when it expires the controller starts to close the door. Details of the four auto-close modes are outlined below.

Standard Auto-Close

This mode is selected by entering a non-zero time for the STD Auto-close parameter. When selected the

door will auto-close after being fully opened (except when the door has reversed to the open position after

a motor obstruction or overload unless A/C after open and/or close Obstruction are selected). Countdown is

suspended by: P.E., OPN or SWP input being active. The countdown is aborted if the STP input is activated. If

the door is already open and the OPN or the SWP input is activated then the countdown will start.

PE Beams Triggered Auto-Close

This mode is selected by entering a non-zero time for the “PE Beams Auto-close” parameter. This mode is

used to auto-close the door but only after a vehicle have passed through the doorway and triggered the PE

Beams input. The swipe input can be used to clear the P.E triggered status so that the PE Beams input must

be activated again before the countdown will start. As with the other PE Beams modes the STP input will abort

countdown and the OPN and SWP inputs will restart the countdown if the door is OPEN.

Pedestrian Access Auto-Close

This mode is selected by entering a non-zero time for the “Ped’n A/C” parameter. When selected, the door will

auto-close after being opened for pedestrian access unless it was following a reverse from an obstruction.

PE Beams triggered pedestrian auto-close

This mode is selected by entering a non-zero time for the “P.E. Ped’n A/C” parameter. This mode is the

same as the PE Beams triggered auto-close mode but it only operates during pedestrian access. As the

SWP input is not available during pedestrian access, the PED input can be conﬁ gured to act in a SWP

mode by setting the “PED I/P = PED SWIPE MODE” parameter to ON.

Auto-Close After Obstruction

Three parameters are provided to enable the auto-close feature to be activated after obstructions and power

up. Normally the auto-close feature is not enabled after obstructions for safety reasons. P.E beams must be

used for these features to be activated.

Auto-close mode