Installation manual

38
GDO-10V1 Toro
®
Owner Installation Instructions
62
fi g
LIGHT
LOCK
LIGHT
NO
NC
COM
NO
NC
COM
SUITABLE
POWER
SUPPLY
Parameter Min Max Default Step Unit Menu No.
ON AFTER CYCLE LIGHT TIME
Time light remains on for after a cycle
0 255 60 1 Sec 5
ON BEFORE OPEN CYCLE LIGHT TIME
Minimum time light is activated for prior to
opening
0 25.5 0 0.1 Sec 5
ON BEFORE CLOSE CYCLE LIGHT TIME
Minimum time light is activated for prior to
closing
0 25.5 0 0.1 Sec 5
Step 15.1 Fitting Courtesy Lights
An AC or DC courtesy light can be activated via an
output on the door opener control board. Connect the
light as per the diagram at right. (Fig. 62)
WARNING: A qualifi ed electrician must perform
the installation where 240V AC power is used.
Menu 5. Light times
Press NEXT or PREV on the wall control unit to
navigate to the Menu 5 Light Times.
Press SET to select the sub menu .
Press NEXT or PREV to navigate through the sub
menu.
Press OPEN to increase or CLOSE to decrease
value
Press SET to save the new value.
Press STOP button two times to exit.
Test the light operation.
1.
2.
3.
4.
5.
6.
7.
Accessories Installation