Installation manual

34
GDO-10V1 Toro
®
Owner Installation Instructions
The functions available are:
RX = Off
From the time when program with RX = OFF
activate, all the transmitters will be disabled.
RX = On
From the time when program with RX = ON
activate, all coded transmitters will be enabled.
Open Door
From the time when program with OPEN DOOR
activate, the door will open and stays open.
Stop Door
this feature will let the user to activate the stop
function until the next program starts. The door
will not open or close while stop is activated.
Free Door
Release the controls from the timer.
Out = On
From the time when program with OUT = ON
activate, the OUT pin on the terminal block will
remain active until next program starts.
Out = Off
From the time when program with OUT = OFF
activate, the OUT pin on the terminal block will
remain inactive until next program starts.
Out = Rx
The coded transmitter will pulse the OUT output
pin on the terminal block
Note :
That the most recent program that applies to an
output remains active until a new program takes
effect. The program is not just executed at the
programmed time but from the programmed.
Time until another program takes over. This
also means that each output’s state is correctly
restored after power failure, vacation mode and
output disabling.
Note:
If a Time clock program does not have a day
selected then it can not executed.
If a time clock program is taking control of the
opener then this status is displayed on the LCD
as shown in fi g. The MAIN SCREEN and clock
status screen fl ashes alternatively.
Settings
Under this menu three sub menus are available
Run Programs
The programs of the timer can be interrupted by
selecting RUN PROGRAM off.
Confi guration Of Aux I/p
Aux input can be confi gured as osc ,ped or
day light saving setup . Activated by
AUX input terminal with N/O switch.
When Aux Selected As OSC :
If the door is moving the activation of AUX input or
by transmitter button with OSC function assigned
will cause the door to stop. The next trigger will
move the door in the opposite direction to that last
travelled.
When Aux Input Is Confi gured As Ped :
The activation of aux input or by transmitter button
with PED function assigned will opens the door
partially to allow pedestrian access but prevent
vehicle access. The position the door is driven to
is automatically set to halfway during setting of
the travel limits, but can be adjusted to suit.
When Aux Input Is Confi gured As Day Light
Saving :
The AUXILIARY input can be used to switch between
STD time and DST (daylight savings time). The aux
input needs to be constantly active to show day light
saving time.
Day Light Saving Time Adjustment
The time selected is the amount of time added to
STD time when DST is Selected by auxiliary input
Options are OFF, 30, 60, 90 or 120 minutes.
Time clock menu 8