Installation manual

32
GDO-10V1 Toro
®
Owner Installation Instructions
Parameter Min Max Default Step Unit Menu No.
Safety Close Mode OFF On On 7.1
PE Beams INPUT RESPONSE MODE Sets the P.E
response mode. Options are OPEN and CLOSE
cycles stop, Close cycles stop or Close cycle
reverse
OPN & CLS
stop
CLS to stop
CLS to reverse
CLS to
reverse
7.2
GPI INPUT MODE confi gure the GPI input.
Options are OSC, PED and DAY LIGHT SAVING
OSC,
PED,
DST
OSC 7.3
PED INPUT = SWIPE MODE Selects PED input
functions as pedestrian access swipe input
Off On Off 7.4
OPN INPUT N/C OPERATION
Selects operating polarity of OPN input
Off On Off 7.5
OPN I/P = 2ND PE BEAMS OPERATION
Confi gure OPN input to take 2ND PE BEAMS
Off On Off 7.6
STP INPUT N/C OPERATION
Selects operating polarity of STP input
Off On Off 7.7
FIRE INPUT N/C OPERATION
Selects operating polarity of FIRE input
Off On Off 7.8
FIRE INPUT MODE confi gure the fi re input.
Options are OPN, CLS and PED
OPN,
CLS,
PED
OPN 7.9
REMOTE CODE ENABLED
Selects remote transmitter coding function
Off On On 7.10
ACTIVITY REPORTS Select report to be output Off 255 Off 1 7.11
ACTIVITY REPORT ID
Selects ID for controller, sent with activity report
0 65535 0 1 7.12
VACATION MODE
Selects vacation mode - disables remote control
Off On Off 7.13
BATTERY/SOLAR MODE
Selects Battery Back Up/Solar operation
Off On On 7.14
PASSWORD
Selects password protection for all changes
Off On Off 7.15
Transmitter Grouping Off On Off 7.16
Fault Auto Reset
Selects Fault Auto Reset
Off On Off 7.17
Led Low Power Mode
Selects Saving The Power By Turning LEDs Off
Off On Off 7.18
Console OSC Buttons
Selects To Lock Out The Console Buttons
Off On On 7.19
Control Board Adjustments