Installation manual

Owner Installation Instructions GDO-10V1 Toro

Pre-Installation Requirements

IMPORTANT SAFETY INSTRUCTIONS FOR INSTALLATION

Warning: Incorrect installation can lead to severe injury.

Follow ALL installation instructions.

ﬁ g

NOTE:

Planetary chain equipment must be removed from the door

prior to installation of GDO-10.

Door Operation

The door must be in good operating condition. The

maximum effort to move the door up or down, from

stationary, should not exceed 150 Newtons (15 kg force) at

the bottom rail.

Lift the door to about halfway. When released, the door

should stay in place supported entirely by its springs. Raise

and lower the door to check for binding or sticking.

The door may need to be serviced to meet these

requirements – refer to the door manufacturer’s servicing

instructions or contact an authorised dealer.

Unsuitable Door Types

The ﬁ tting of an opener to doors with removable mullions and

a door incorporating a wicket door is not recommended.

Position

The opener can be installed on either the right- or left hand

side of the door (when viewed from inside the garage). The

opener is factory set for right hand side installation.

This opener must be installed in a dry position that is

protected from the weather. Moisture or corrosion damage

is not covered by the Warranty.

Power Supply

Properly earthed 3 pin single-phase power is required.

WARNING! A portable power generator is

not recommended. The opener may appear to

malfunction due to spikes, surges and ﬂ uctuations in

the generated voltage.

Side Room For Right Hand Side Installation

The minimum side room required from the edge of the door

curtain is 140 mm to the inside of the door bracket when

opener mounted on the door bracket (Fig. 04).

NOTE: Door Axle Diameter must not exceed 35 mm.

140

185

ﬁ g

182

127