Installation Instructions

Auto-Lock Installation Instructions
4
StormShield and Tongue & Groove installation (kits sold separately)
preparation - mounting on door stile
3
1
8
a. Fit the mounting bracket
8
or
9
to the lock
mechanism
1
using 2 x
countersunk head screws
M6 x 14
3
.
9
e. Test the operation of the AutoLock
by pressing the lock/unlock button
to ensure the lock bolt fully engages
the striker without interference.
PROCEED TO CONNECTING
BASE STATION TO THE OPENER.
10
11
12
b. Close the door to determine mounting position
between the reinforcing braces on the bottom
door panel and mark. Mount the bracket and
lock mechanism as marked with the 4 flange
head tek screws 20 x 25 CL4
10
, however do
not fully tighten as further final adjustment may
be required.
c. With the door in the closed position align the
striker bracket with the lock
d. Drill 3 x ¼ holes as marked in the tracklock and
fix with 3 x bolts
11
and nuts
12
.
a. Disconnect the power supply to the opener.
b. For ATS-3AM:
i. Remove the left hand side pocket from the opener.
ii. Reach inside the opener and pull out the 4 pin harness
and connect to the wireless basestation module.
For ATS-2AM:
iii. Remove back cover to expose control board.
iv. Reach inside the opener and pull out the 4 pin harness
and connect to the wireless basestation module.
c. Place the module into the pocket and refit the cover.
d. Reconnect power to the opener and test operation.
e. Upon completion of a full cycle the lock will engage into
the track.
ATS-3AM
connect basestation to opener
If a PE Beam is installed ensure that the channels
on the basestation on each device are different.
The channel on the basestation can be changed
by sliding the switch in either direction.
tip
ATS-2AM