Installation Instructions

3
Auto-Lock Installation Instructions
standard installation (side mount)
preparation - no brackets, mounting on track
1
2
a. With the door closed, mark the
position of the top of the second
door wheel on the inside of the track.
b. Place the drilling template
6
label
with the Datum line on top of the line
marked inside.
c. Using an 6mm and 18mm stepped
drill, drill marked holes through the
guide and remove any burs from
holes.
d. Assemble the Autolock
1
to the
track using 2 x screws
2
,
lock bolt flush
with inside of
guide
lock bolt when
engaged with
10mm clearance
e. Close the door and check the position
of the lock to the wheel, there should
be a 10mm clearance.
f. Test the operation of the AutoLock
by pressing the lock/unlock button
to ensure the lock bolt fully engages
through the guide without interference.
PROCEED TO CONNECTING
BASE STATION TO THE OPENER.
limited side room installation (door mount)
preparation - brackets, mounting on door
10
11
12
1
6
a. Remove the lock
drive unit from the
lock mechanism by
depressing the two
tabs on the top and
bottom of the unit
and pulling apart.
b. Close door and mark mounting position of both
striker and lock, by holding in place.
c. Open door and affix the striker bracket
6
to the
track with 3 x bolts
11
and nuts
12
.
d. Close the door, align the lock mechanism
1
on
the bottom panel door stile so that the lock bolt
engages fully into the striker bracket
6
and fix
using 4 x flange head tek screws
10
.
e. Fit the lock drive unit to the lock mechanism.
f. Test the operation of the AutoLock by
pressing the lock/unlock button to ensure
the lock bolt fully engages the striker
without interference.
PROCEED TO CONNECTING BASE STATION
TO THE OPENER.