Instruction Manual

ManualsBrandsAutomatic Technology ManualsElectronicsDOMINATOR SYNCRO Overhead Garage Door Operator

ATS-3AM & ATS-2AM Dominator Tempo & Syncro Instruction Manual

B - Adjustment Mode Instructions

a. Press the MODE button repetively until the GEAR LED starts flashing

b. Referring to the table below, select the desired parameter using the OPEN

and CLOSE buttons and observing the number of flashes on

the GEAR

LED. The selected parameter’s value is indicated by the main light’s brightness.

c. Press STOP / SET button to start editing the parameter’s value. The TRANSMIT

LED will turn on when editing is active.

d. Use the OPEN

and CLOSE buttons to step through the available options. The light’s brightness will change accordingly.

When parameter edit

mode is active, if any

button other than MODE

is pressed, then when

MODE is pressed again,

operating mode will be

selected instead of the

NETWORK adjustment

mode.

tip

e. Press STOP / SET button to save the parameter’s new value or press MODE to leave the value unchanged.

f. Continue from a. above to select another parameter or press MODE to exit adjustment mode.

Pressing the MODE button when a parameter is

being adjusted will load the default value.

tip

Parameter Value options = Indicated by brightness

of main light

(DEFAULT parameter underlined)

Name Flashes 1 2 3 4 5 6

MARGIN x1 1.0A 1.2A 1.4A 1.6A 2.0A -

PE AUTO-CLOSE x2

OFF 15sec 30sec 60sec 90sec -

AUTO-CLOSE x3

OFF 15sec 30sec 60sec 90sec 120sec

LIGHT TIMER x4 30sec 60sec 90sec 120sec

180sec 240sec

AUX OUTPUT x5

Mimic

light

1sec 30sec 60sec 120sec 180sec 240sec 300sec 600sec toggle

OSC INPUT x6

OPEN/STOP/CLOSE DOOR OPEN/HOLD OPEN

AUX OUPUT

• Configures how the AUX Output operates. If configured for Mimic light mode then

the AUX output will activate whenever the main light output is on. All other settings

require either a remote control code set to the AUX function or the Phone App to be

used to activate the output. The time settings option indicate how long the output

will remain on when triggered. If the output is already on then a 2nd trigger will turn

the output off. The toggle On/Off setting does not use a timer and the output simply

changes state on each trigger.

OSC Output

• By default the OSC input is used to open, close or stop the doors movement. When

DOOR OPEN/ HOLD OPEN is selected activating the OSC input will open the door.

If the input is held active then the door will not be able to be closed until after the

input is released.