Instruction Manual

ManualsBrandsAutomatic Technology ManualsElectronicsDOMINATOR SYNCRO Overhead Garage Door Operator

Diamond PD Power Drive : Instruction Manual

Dominator Tempo & Syncro Instruction Manual ATS-3AM & ATS-2AM

6.12 Homelink

Some vehicles may require the ignition be turned

on to program the HomeLink

Button.

tip

WARNING! Ensure to have hand brake on whilst setting

homelink button and do not allow anything to stay in or

near the path of the door. Keep people away until the door

is completely opened or closed.

AVERTISSEMENT : Assurez-vous que le frein à main est

activé lors du réglage du bouton homelink et ne laissez

rien rester dans ou près du chemin de la porte. Éloignez

les personnes jusqu’à ce que la porte soit complètement

ouverte ou fermée.

6.12.1 Coding in the HomeLink

button

a. Press and hold the two outside buttons on the HomeLink

system until the

LED starts to blink, release buttons.

b. Hold the ATA single button remote control

in hand and position it 1-3

inches (3-8cm) from the HomeLink

button as in 6.12.1.

c. Press and hold the desired HomeLink

button and ATA single button

the same time until the HomeLink

LED changes from a slow blink to a rapid

blink.

d. Release both buttons. The HomeLink

button is ready to be coded into the

ATS-Series garage door operator.

6.12.2 Coding HomeLink

button into the ATS-Series Operator

a. Press the MODE button repetitively until the TRANSMIT LED is flashing

slowly.

b. Press and release the CLOSE button

- operator will start to flash and

beep slowly for 20secs to allow the user to go to the car.

c. After 20 seconds the operator will start to beep and flash quickly. Press and

hold the HomeLink

button to be code set for 2 secs.

d. Release the HomeLink

button for 5 seconds, then press and hold the same

HomeLink

button again for 2 secs - the flashing and beeping will stop.

e. Test the operation of the HomeLink

button.

6.12.3 Erasing all HomeLink

buttons from the ATS-Series Operator

a. Press the MODE button repetitively until the TRANSMIT LED is flashing

slowly.

b. Press and hold MODE button.

c. The operator will start to flash and beep after 5 seconds. When the flashing

and beeping stops, release the MODE button.

Park the vehicle outside of the garage where the

opening is clearly visible and leave window down to

hear sounds.

tip

Keep the ATA Single Button Remote Control

in a safe place

for future use. This will be needed if and when you change cars.

tip

Fig.6.12.1