Instruction Manual

Diamond PD Power Drive : Instruction Manual
Dominator Tempo & Syncro Instruction Manual ATS-3AM & ATS-2AM
21
© Copyright 2019
Your opener must be fitted with SAFETY BEAMS. Safety Beams detect any obstructions in the door’s path and
override automatic operation if one presents. These must be installed as in accordance with UL 325 and CSA C222.2
No 247.
This is in addition to regular professional servicing, and monthly obstruction tests as detailed in your opener’s Owners
Manual.
The compliance to FCC radiation exposure limits for an uncontrolled environment, and a minimum of 20cm separation
between antenna and body. This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Votre ouvre-porte doit être équipé de FAISCEAUX DE SÉCURITÉ. Les faisceaux de sécurité détectent tout
obstacle sur le trajet de la porte et annulent alors le fonctionnement automatique. Ceux-ci doivent être installés
conformément aux normes UL 325 et CSA C222.2 N° 247.
Ceci s’ajoute à l’entretien professionnel régulier et aux tests d’obstruction mensuels détaillés dans le mode d’emploi
de votre ouvre-porte..
Conformité aux limites d’exposition aux rayonnements FCC pour un environnement non contrôlé, et distance minimale
de 20 cm entre l’antenne et le corps. Ce dispositif est conforme à la partie 15 des règles de la Federal Communications
Commission (FCC). Son fonctionnement est assujetti aux deux conditions suivantes: (1) Ce dispositive ne doit pas provoquer
de brouillage préjudiciable, et (2) il doit accepter tout brouillage reçu, y compris le brouillage pouvant entraîner un mauvais
fonctionnement.
6.9.1 Connecting to Wifi
The Smart Phone Control works via your home’s WiFi network. Initial
set up involves linking your phone app, smart hub and opener to your
home network.
a. Download the ATA App.
b. Ensure the WiFi router is within range of the opener.
c. On the opener press the MODE button repetitively until the
NETWORK
LED is lit. (Fig 6.9.1)
d. Press and hold the OPEN button on the opener for 4 seconds. The
NETWORK
LED will turn purple when Hot Spot is Active.
e. Go to phone settings, then WiFi and select (ATA000000).
f. Open App and tap on Start.
g. Select setup a new Smart Hub
h. When Smart hub hotspot connection appears, select OK got it.
i. Ensure WiFi network = (ATA000000) then select connect to hub.
j. The opener main light and a red NETWORK
LED will start to
flash.
k. Press STOP / SET button on the opener.
l. Name your smart hub on the app and select SAVE.
Ensure limits are set prior to connecting to Wifi.
tip
m. Set the time zone and SAVE.
n. Create an admin user and select “OK got it”.
o. Fill in name and password and select CREATE.
p. Fill in email and security question or select skip this step and select
SAVE.
q. Select the push notification and select SAVE.
r. Select and connect to WiFi. Choose your home WiFi and fill in
password and select connect.
s. The NETWORK
LED will change to solid blue.
t. Now you can test the app.
Fig.6.9.1
6.9 Auto-Ki Smart Phone Control
(ATS-3AM & ATS-3AMB Only)
ATA App local operation will continue when the internet
is down and the home router Wi-Fi is operational.
tip