Instruction Manual
18
ATS-3AM & ATS-2AM Dominator Tempo & Syncro Instruction Manual
Fig.6.6.3
Fig.6.6.4
6.6 Coding Premium Remote Controls
Fig.6.6.2
IMPORTANT WARNING
LOCATE THE WALL MOUNTED REMOTE CONTROL:
(1) WITHIN SIGHT OF DOOR.
(2) AT MINIMUM HEIGHT OF 5 FEET ABOVE FLOORS,
LANDINGS, STEPS OR OTHER ADJACENT WALKING
SURFACE SO SHALL CHILDREN ARE NOT ABLE TO
REACH IT, AND
(3) AWAY FROM MOVING PARTS OF THE DOOR.
(4) PLACE THE ATTACHED ENTRAPMENT WARNING LABEL
ON WALL NEXT TO WALL MOUNTED TRANSMITTER.
USE AN ADDITIONAL MECHANICAL MEANS (PLATE,
BOARD, ETC.), WHICH CAN SECURE THE LABELS
TO SURFACES TO WHICH THE ADHESIVE WILL NOT
ADHERE.
(5) DO NOT REMOVE OR PAINT OVER THIS LABEL.
IMPORTANT
PLACEZ LA TÉLÉCOMMANDE MURALE:
(1) EN VUE DE LA PORTE.
(2) À UNE HAUTEUR D'AU MOINS 1,50M (5PIEDS) AU-
DESSUS DU SOL, DU PERRON, DES MARCHES, ETC.
AFIN QUE LES PETITS ENFANTS NE PUISSENT PAS
L'ATTEINDRE,
(3) ET À DISTANCE DES ÉLÉMENTS MOBILES DE LA PORTE.
(4) PLACEZ L'ÉTIQUETTE AVERTISSANT DU RISQUE
DE SE FAIRE PIÉGER SUR LE MUR À PROXIMITÉ DE
L'ÉMETTEUR. UTILISEZ UN SUPPORT PHYSIQUE
SUPPLÉMENTAIRE (PLAQUE, PANNEAU, ETC.)
PERMETTANT DE FIXER LES ÉTIQUETTES SI ELLES
N'ADHÈRENT PAS À LA SURFACE DU MUR.
(5) CETTE ÉTIQUETTE NE DOIT PAS ÊTRE RETIRÉE NI
PEINTE.
6.6.2 Erasing All Premium Remote Control Codes
a. Press the MODE button repetitively until the TRANSMIT LED is lit.
b. Press and hold the MODE button for 10 secs, let the MODE button go
when the main light stops flashing.
c. Follow steps a - e in 6.6.1 Setting the Premium Remote Control Code to
code new remote controls.
6.6.3 Vacation Mode
a. To turn on Vacation mode and lock out all remote controls, press the
button on the remote programmed with Vacation Mode.
b. To turn off Vacation Mode, press the Premium Remote Control button
programmed to vacation mode to turn off.
6.6.4 Remotely Coding Premium Remote Controls
Using this method remote controls can be coded without access to the
opener’s control panel as long as a pre-coded remote control is available.
a. Take any pre-coded Premium Remote Control. Press the button for the
function to be duplicated and release.
b. Using a small pen, press and hold firmly for two seconds the middle
button, through the Coding Hole (Fig 6.6.2).
c. Within ten (10) seconds take the additional remote control you wish to
code. Hold the new remote controls button for two seconds, pause for
two seconds, hold again for two seconds and then release.
d. Wait for ten (10) seconds and then press the new remote controls
button to test.
6.6.5 Install Premium Wall Control
a. Turn the Premium Wall Control over and pull the tab to commission the
battery.
(Fig 6.6.3)
b. Store the Remote Control Function as per instructions in Section 6.6.1.
Test the Premium Wall Control button.
c. Mount the Premium Wall Control using parts provided in a convenient
location, yet out of reach of children and at least 5 feet off the ground.
(Fig 6.6.4)
d. Make sure the door is visible from this location.