Instruction Manual
12
ATS-3AM & ATS-2AM Dominator Tempo & Syncro Instruction Manual
Fig.6.2.7
7
12
9
4
13
6
10
9
12
8
5
A
6.2.7 Attaching the Arms
a. Assemble the bent arm
4
(connecting to the door) to the right side
of the straight arm
5
with bolts
10
and nuts
13
supplied in the
accessory pack. Connect the straight arm
5
to the shuttle with a
clevis pin
12
and a pin snap
9
. Always use both bent and straight
arms (Fig 6.2.7).
b. Connect the assembled arm to the bracket with clevis pin
12
and
pin snap
9
. The angle “A” must be more than 10°.
6.2 Mounting Operator for a Track Type Door
WARNING! connecting the bent arm other way
around may damage the door.
AVERTISSEMENT! Si vous fixez le bras coudé à
l’envers, vous risquez d’endommager la porte.
IMPORTANT NOTE: If the manual release handle is more than
5.91ft (1.8 meters) from floor level when the operator is installed,
extend the handle to a height 5.91ft (1.8 meters).
IMPORTANT: Si la poignée de déverrouillage manuel est à plus
de 1,80m (5,91’) de hauteur quand le dispositif d’ouverture est
installé, la poignée doit être placée à 1,80m (5.91’) de hauteur.