Troubleshooting guide

Owner Installation Instructions GDO-7v2 SecuraLift® 25
Parameters
Door Status Indicators
Buttons Function
OPERATE Opens/Stops/Closes the door
DOOR CODE Codes a transmitter button for operate function
LIGHT CODE Codes a transmitter button for light function
DOOR CODE & MINUS (-) Codes a transmitter button for pet
(pedestrian function
LIGHT CODE & MINUS (-) Codes a transmitter button for vacation function
FORCE MARGIN SET & PLUS (+) Increases the obstruction force margin setting
FORCE MARGIN SET & MINUS (-) Decreases the obstruction force margin setting
FORCE MARGIN SET (then) SET Reloads the factory set default obstruction force
margin setting
AUTO CLOSE TIME (then) PLUS (+) Increases the auto close delay time
AUTO CLOSE TIME (then) MINUS (-) Decreases the auto close delay time
AUTO CLOSE TIME (then) SET Reloads the factory set default auto close delay time
FORCE MARGIN SET & AUTO CLOSE TIME (then)
PLUS (+)
Each press of the open button increases the light time
by 10 secs.
FORCE MARGIN SET & AUTO CLOSE TIME (then)
MINUS (-)
Each press of the open button decreases the light time
by 10 secs.
FORCE MARGIN SET & AUTO CLOSE TIME (then)
SET
Reloads the factory default light time
MINUS (-) (for 6 secs.) Clears the door limits set positions. Limits then need to
be reset
SET & CLOSE (for 2 secs.) Enters pet (pedestrian) position mode
SET (then power on) & hold until all LEDs are off Deletes control parameters excluding transmitter
storage memory
DOOR CODE (then power on) & hold until all LEDs
are off
Deletes all transmitter storage memory
SET & DOOR CODE (the power on) and hold until all
LEDs are off
Deletes all control parameters and transmitter storage
memory.
SET Re-initialises the Opener to re-calculate force margin