Troubleshooting guide

Owner Installation Instructions GDO-9v2 SecuraLift

Parameters

Button Functions

Buttons Function

OPERATE Opens/Stops/Closes the door

DOOR CODE Codes a transmitter button for operate function

LIGHT CODE Codes a transmitter button for light function

DOOR CODE & CLOSE Codes a transmitter button for pet mode

LIGHT CODE & CLOSE Codes a transmitter button for vacation function

FORCE MARGIN SET & OPEN Increases the obstruction force margin setting

FORCE MARGIN SET & CLOSE Decreases the obstruction force margin setting

FORCE MARGIN SET (then) SET Resets the factory default force margin settings

AUTO CLOSE TIME (then) OPEN Increases the auto close delay time

AUTO CLOSE TIME (then) CLOSE Decreases the auto close delay time

AUTO CLOSE TIME (then) SET Resets the factory default auto close delay time

FORCE MARGIN SET & AUTO CLOSE TIME (then) OPEN Each press of the PLUS (+) button increases the

light time by 10 secs.

FORCE MARGIN SET & AUTO CLOSE TIME (then)

Each press of the MINUS (-) button decreases the

light time by 10 secs.

FORCE MARGIN SET & AUTO CLOSE TIME (then) SET Reloads the factory default light time

CLOSE (for 6 secs.) Clears the door limits set positions. Limits then

need to be reset

SET & CLOSE (for 2 secs.) Enters pet (pedestrian) position mode

SET (then power on) & hold until all LEDs are off Deletes control parameters excluding transmitter

storage memory

DOOR CODE (then power on) & hold until all LEDs

are off

Deletes all transmitter storage memory

SET & DOOR CODE (the power on) and hold until all

LEDs are off

Deletes all control parameters and transmitter

storage memory.

SET Re-initialises the Opener to re-calculate force

margin