Troubleshooting guide

GDO-11v1 SecuraLift

Owner Installation Instructions

Parameters

Door Status Indicators

Door Opener State OPEN LED (Green) CLOSE LED (Red) Beeper

Open On

Close On

Opening Flashing

Closing Flashing

Door travel stopped Flashing Flashing

Door obstructed when opening Flashing

Door obstructed when closing Flashing Beeps as door moves

Opener overloaded Alternating ﬂ ashes Alternating ﬂ ashes

Pet Mode Engaged On On

Mains power interrupted Rapid ﬂ ashes

Button Functions

Buttons Function

OPERATE Opens/Stops/Closes the door

DOOR CODE Codes a transmitter button for operate function,

Vacation function, Auxilary function, Pet mode and

Light function

FORCE MARGIN SET & OPEN Increases the obstruction force margin setting

FORCE MARGIN SET & CLOSE Decreases the obstruction force margin setting

FORCE MARGIN SET (then) SET Resets the factory default force margin settings

CLOSE (for 6 secs.) Clears the door limits set positions. Limits then

need to be reset

PLUS(+) (for 6 secs.) Enters pet (pedestrian) position mode

SET (then power on) & hold until all LEDs are off Deletes control parameters excluding transmitter

storage memory

DOOR CODE (then power on) & hold until all LEDs

are off

Deletes all transmitter storage memory

SET & DOOR CODE (the power on) and hold until all

LEDs are off

Deletes all control parameters and transmitter

storage memory.

SET Re-initialises the Opener to re-calculate force

margin