Specifications

EASY ACCESS TRANSMITTER

PRESS BUTTON

ROTATE

FIG. 4

FIG. 5

FIG. 6

4. EASY ACCESS TRANSMITTER

The Easy Access Transmitter is prepared ready for use with the

battery pre-installed. Before the transmitter can be operational,

the transmitter code has to be stored into the openers memory.

To store the code refer to Step 10.1 on page 15.

REMOVING THE COVER TO REPLACE BATTERY

1. Rotate the cover Clockwise to CLOSE

2. Rotate the cover Anti-clockwise to OPEN

REMOVING THE BATTERY

(Battery Type: 3V Lithium Battery CR1220).

Use a non-metallic object (e.g pen) to remove the battery.

Gently lever the battery out of the holder, taking care to not

damage the circuit board. (Fig. 6)

WARNING

Metallic objects used to remove the battery may damage the

circuit board or the battery.

REPLACING THE BATTERY

Make sure that positive (+) side is facing up. Place one side of

the battery into the holder (Fig. 7), then press the battery in and

down firmly until it clicks into a flat position.

Note: The length of the manual release cord is user adjustable.

Simply slide the plastic toggle along the cord to achieve the

desired length. Adjust the length of the cord so that it can be

easily reached by an adult of average height (ie. less than 1.8m

tall).

FIG. 7

Note: Positive (+) side up