Installation manual

16
ET BLUE ROLL Beeps schedule and trouble shooting guide.
Beeps
Door
position
220V
mains
on/off
Battery
charged/dis-
charged
Door Action Status
Command used
to cause beep/s
1
Anywhere On On None Initial power up Power applied
2 Closed Off Charged
Door will
open
after beeps
Mains failure BT triggered
3 Open Either Either
Door will
close
after beeps
Autoclose active
and
door is about to
close
Autoclose or
BT triggered
4 Closed Either Either None
Holiday lock out
"unlocking"
confirmation
Courtesy light
button
held for >10 sec.
5
Rapid
Closed Either Either None
Holiday lock out
"locking or locked"
confirmation
Courtesy light
button
held for >10 sec.
Or BT triggered
15 Anywhere Off Dis-charged None
Battery charge
level
is less than
minimum allowed
BT triggered
Once
every
16sec.
Anywhere On Charging Will operate
Battery charge
level is less than
minimum allowed
and busy
charging
None
In case of any misunderstanding of the beep tones contact your nearest ET Branch product support centre
for assistance.
These beeps are important warnings to help prevent damage to the unit. Your client should be instructed on
the use of them.
When contacting any of our support centres please have a record of any beep activity. This will assist in the
accurate diagnostic of the fault and assist us in maintaining our high expectancy of support for our products.
You may be asked to take readings with a multi-meter. Please have one handy. If you are not proficient in
the use of a multi-meter please contact a service provider in your area. Your nearest ET Systems branch will
have contact details of preferred service providers in your area.