Installation manual

Owner Installation Instructions GDO-8 Shed Master® 19
Remote Code Set Procedure
If a transmitter is already coded into the opener,
additional transmitters can be coded without being in
direct contact with the opener.
NOTE: Only the function of the existing transmitter
button can be assigned to new transmitter. Please read
instructions prior to proceeding - there is a time-out
facility for security reasons.
10.1 Selecting the function to be coded
Using the existing transmitter, operate the door with
the transmitter button which has the function to be
coded (Fig. 15) (e.g. Button 1 has been coded with the
OSC function assigned).
10.2 Wait for door to complete cycle
If the button’s function activates the door (OSC) wait
for the door to complete its cycle.
10.3 Activate remote code set mode
Using a small pin press and hold through the Coding
Hole of the existing transmitter for two seconds (Fig.
16).
10.4 Code new transmitter button
Within 10 seconds, press the button on the new
transmitter you wish to code for 2 seconds (Fig. 17).
10.5 Confi rm transmitter button to be
coded
Press the same button again (within 10 seconds)
for confi rmation.
10.6 Test operation
The new transmitter button should now function as the
existing transmitter.
15
fi g
16
fi g
Existing
transmitter
New
transmitt
er
PRESS
PRESS
Existing
transmitter
17
fi g