Installation manual

GDO-8 Shed Master® Owner Installation Instructions

Coding Transmitters

ﬁ g

Press and hold

Door Code button

Select one of the four

buttons you wish to use

to control the door

9. Setting transmitters codes

The memory in the openers receiver can store up to (8)

eight remote control transmitters.

9.1 Code a Transmitter Button for Door

Operation

Press and hold the DOOR CODE button (Fig.

14).

Press one of the four buttons on the transmitter for

two (2) seconds, pause for two (2) seconds, then

press the same button again for two (2) seconds.

Release the DOOR CODE BUTTON.

Press the transmitter button to test.

9.2 Coding a Transmitter Button to the

Courtesy Light

The transmitter can be programmed to operate the

courtesy light on the opener independently of the door

moving. Connect the external secure light module to the

opener then:

Brieﬂ y press the DOOR CODE button once, then

press it again and hold (will beep two times on

second press).

Press one of the four (4) buttons on the transmitter

for two (2) seconds, pause for two (2) seconds,

then press the same button again for two (2)

seconds.

Release DOOR CODE button.

Press the transmitter button to test the light.