Instruction manual

GDO-6v3 EasyRoller

Owner Installation Instructions

ﬁ g

Final Setup

Step 16 - Setting of Courtesy Light Time

The preset courtesy light time is three minutes. This time

can only be changed by a “PG3” programmer.

Step 17 - Setting the Pet Mode position

The default Pet Mode height can be changed as follows:

Drive and stop the door at the desired Pet Mode

open position by pressing O/S/C button on the

console or the transmitter button coded for O/

S/C operation.

Press and hold the OPEN button for six (6)

seconds until the OPEN and CLOSE LED’s are lit

to record the new pet position.

When activated, Pet Mode drives the door to the preset

position from the close position. Pet Mode’s active status

is indicated by both the OPEN and CLOSE LIMIT LED’s

being illuminated. If a Pet Mode button is pressed while

the door is moving, the door will stop. If a Pet Mode

button is pressed when the door is in the Pet position,

then the door will close.

Step 18 - Installing the Wall Mounted

Transmitter (Optional)

Remove the faceplate from the transmitter.

Afﬁ x the baseplate in a convenient wall location

(Fig 30) where the door is visible but out of the

reach of children at a height of at least 1.8 metres

from the ﬂ oor.

Replace the faceplate.

To code the transmitter, see Steps 10.1 through

10.4 on page 19.

Step 19 - Keyswitch Connection

The GDO-6 has the input to connect bell switch or

keyswitch to open or close the door. Connect the key/

bell switch as per diagram (Fig. 31).

ﬁ g

AUX OUT

OSC

GND

PE (0V)

30V PWR