Instruction manual

Owner Installation Instructions GDO-6v3 EasyRoller

ﬁ g

Auto-Close

Step 15 - Setting Up Auto-Close Mode

IMPORTANT NOTICE: It is compulsory to have PE

Beams installed when using Auto-Close mode.

Auto-Close mode is a function that automatically closes

the door a preset time after the PE Beams recognise that

a vehicle has left the garage.

The Auto-Close timer only starts after the PE Beam’s

path is broken. If the PE path is not broken, the door will

remain open until the path is broken. If the opener incurs

a physical obstruction (i.e. not from the PE Beams) while

closing the door, it will re-open and not Auto-Close until

the PE Beam’s path is broken again.

Step 15.1 - Setting Auto-Close Time

Hold down the AUTO CLOSE TIME button (Fig. 31).

While holding in the AUTO CLOSE TIME button,

press the OPEN button - each press will add one

second to the Auto-Close delay.

To decrease the delay time follow Step 15.1(a)

and press the CLOSE button - each press will

deduct one second from the Auto-Close delay.

Press the OPERATE button or transmitter to open

the door. When the door is fully opened the

OPEN LIMIT LED will ﬂ ash to indicate that Auto-

Close mode is operational.

Break the PE Beam’s path momentarily to

initialise Auto-Close. When the door reaches the

fully opened position, the door will pause for the

set Auto-Close time and then close.