Instruction manual

Owner Installation Instructions GDO-6v3 EasyRoller
®
21
27
fi g
Deleting Transmitter Codes
Step 13.1 - Deleting a Stored Transmitter
Code
Select the transmitter you want to delete.
Press and hold the DOOR CODE BUTTON (Fig.
27).
Press the transmitter button you would like to
delete for two (2) seconds, pause for two (2)
seconds, press again for two (2) seconds and then
release.
Release the DOOR CODE BUTTON. The code
should now be deleted. Confi rm this by pressing
the transmitter button - the function (e.g. door
opening) should not respond.
Step 13.2 - Deleting All Transmitter Codes
Turn off power to the opener.
While switched off, press and hold the DOOR
CODE BUTTON (Fig. 27). Turn on the power to
the opener while holding this button.
The OPEN LIMIT, CLOSE LIMIT and DOOR
STATUS LED’s will illuminate for about fi ve
(5) seconds. These LED’s will turn off and the
CODING LED will illuminate.
Release the DOOR CODE BUTTON. All stored
codes will now be deleted. Confi rm this by
pressing buttons on any previously coded
transmitters - the opener should not respond.
a.
b.
c.
d.
a.
b.
c.
d.