Instruction manual

Owner Installation Instructions GDO-6v3 EasyRoller
®
19
Step 10.1 - Code a Transmitter Button for
Door Operation
Press and hold the DOOR CODE button (Fig. 20).
Press one of the four buttons on the transmitter for
two (2) seconds, pause for two (2) seconds, then
press the same button again for two (2) seconds.
Release the DOOR CODE BUTTON.
Press the transmitter button to test.
Step 10.2 - Coding a Transmitter Button to
the Courtesy Light
The transmitter can be programmed to operate the
courtesy light on the opener independently of the door
moving.
Press and hold the LIGHT CODE button (Fig.
21).
Press one of the four buttons on the transmitter for
two (2) seconds, pause for two (2) seconds, then
press the same button again for two (2) seconds.
Release the LIGHT CODE button.
Press the transmitter button to test.
Step 10.3 - Code a Transmitter Button for Pet
(Pedestrian) Mode
Briefl y press the DOOR CODE button three times,
then press it again and hold (will beep four times on
fourth press (Fig. 22)).
Press one of the four buttons on the transmitter for
two (2) seconds, pause for two (2) seconds, then
press the same button again for two (2) seconds.
Release the DOOR CODE button.
Press the transmitter button to test.
To change the default pet (pedestrian) door opening
position, refer to step 17.
Step 10.4 - Code a Transmitter Button to
Enable Vacation Mode
The opener can be programmed into a “Vacation
Mode” where the opener will not respond to any
transmitter except the button of the transmitter that was
programmed for vacation mode.
Briefl y press the DOOR CODE button once, then
press it again and hold (will beep two times on
second press (Fig. 23)).
Press one of the four (4) buttons on the transmitter
for two (2) seconds, pause for two (2) seconds,
then press the same button again for two (2)
seconds.
Release DOOR CODE button.
Press and hold the transmitter button for six (6)
seconds to set Vacation Mode. The door code
LED will stay lit while Vacation Mode is active.
To reset Vacation Mode, press the same button
for two seconds.
a.
b.
c.
d.
a.
b.
c.
d.
a.
b.
c.
d.
e.
a.
b.
c.
d.
e.
Coding Transmitters
20
fi g
21
fi g
22
fi g
23
fi g