Instruction manual

ManualsBrandsautomatic tech ManualsGarage Door OpenerGDO-6v3 EasyRoller

Owner Installation Instructions GDO-6v3 EasyRoller

Programming the Opener

ﬁ g

Step 6.1 - Setting Travel Limits

NOTE: If PE Beams are to be used they must be installed

before setting the travel limits.

WARNING! Use caution when operating the manual

release with the door open since it may fall rapidly

due to weak or broken springs, or an improperly

balanced door.

CAUTION! Do not disengage the opener to manual

operation with children, persons or any objects

including motor vehicles within the doorway.

NOTE: To access the console, remove the controls lid

cover and reattach when setup is completed.

Move the door to halfway open. If necessary,

disengage the opener by pulling the cord down (Fig.

11).

Re-engage the opener by pulling the cord down.

Turn on the power to the opener. The CLOSE LIMIT

LED will be ﬂ ashing.

Press and hold the CLOSE button - the door should

start closing (Fig. 12).

If the door opens, release the CLOSE button and

press the OPERATE button once to change the

motor’s direction. Press the CLOSE button again to

close the door.

Release the CLOSE button when the door is near the

desired closed position. Single presses of the CLOSE

button will “inch” the door closed.

If the door overshoots, press the OPEN button to

move the door in the open direction.

When the door is at the desired close position, press

the SET button to record the close limit position. The

OPEN LIMIT LED will now ﬂ ash.

Press and hold the OPEN button to open the door.

Release the OPEN button when the door is near the

desired open position. Single presses of the OPEN

button will “inch” the door open.

If the door overshoots, press the CLOSE button to

move the door in the close direction.

WARNING! Once the next step is performed, the

door will automatically close and open to calculate

force settings. Keep persons and objects clear of the

door until it stops and the opener sounds a beep.

Press the SET button to store the open limit. Please

read the above warning.

Step 6.2 - Resetting Travel Limits

To reset the limits, press and hold the CLOSE button for 6

seconds until the CLOSE LIMIT LED ﬂ ashes quickly. If no

action is taken within 30 seconds, the opener will return

to normal operating mode and restore the original limit

settings.