Instruction manual

ManualsBrandsautomatic tech ManualsGarage Door OpenerGDO-6v3 EasyRoller

GDO-6v3 EasyRoller

Owner Installation Instructions

Installation

Step 1 - Preparation

Check the door’s operation:

The door must travel smoothly and be

easy to operate by hand.

Operating force on the bottom rail should

be approximately 70N (7kgs) force.

Adjust any tight or twisted guides/tracks

Clean the guides if there is any oil or wax

present using a suitable white spirit. The

only lubricant suitable for use on door

guides is silicon spray. DO NOT use WD-

40, RP-7, petroleum grease, or similar.

Install the locking bar covers if there are locking bar

holes in the guides. (Fig.03)

IMPORTANT NOTE - Do not lock your door

with the locking bars after installing the opener.

Remove or disable the lock using wire or cable

ties. Security is not affected as the opener has an

inbuilt locking facility.

Afﬁ x the warning labels supplied with this opener in

a prominent place where they are clearly visible.

Choose the side where the opener will be installed,

ensuring there is sufﬁ cient sideroom.

Step 2 - Fit the Weight Bar

The weight bar must be ﬁ tted to the bottom-centre for

proper operation of the opener.

If the door has a handle:

Remove the door handle

Fit the weight bar and reﬁ t the handle using the

new fasteners provided (Fig.04).

If the door does not have a handle:

Locate the centre of the door at the bottom rail

(Fig.05).

Place the weight bar at this point (there is a

centreline marked on the weight bar) and mark the

two positions where the fasteners will go.

Drill the two 4.5mm holes in the door and ﬁ t the

weight bar using the new fasteners provided.

(Fig.06).

Check that the door is still balanced and smooth to

operate. If it is not, then the door may require servicing

(refer to door manufacturer’s instructions).

WARNING! The door and its springs are under

signiﬁ cant tension. Adjustments should only

be carried out by experienced persons, as this

function can be dangerous if not performed under

strict safety procedures.

ii.

iii.

iv.

ﬁ g