Instruction Manual

4 Channel Motor Controller

Installation and Operating Instructions

Product Description: 4 Channel Motor Controller

Part Number: MT02-0401-331011

Before installing the 4 Motor Controller, ensure all motors have their limits set and are operating correctly.

Note: Refer to the motor datasheet for maximum run time.

AC Output

Motor 1 Motor 1 Motor 1 Motor 1 Switch 1 Switch 3 Switch 5Switch 2 Switch 4 Switch 6

Push Terminal Port

Connections and Indicators

Initial Setup

Installation

Connect all motors and switches to the outputs of the controller

Product Details

MT02-0401-331011_4 Channel Motor Controller_v2.0_December 2022

AC Input

Earth Rail Rod

AC Output

Fuses

Motor LEDs

Power LEDs

Master Mode DIP Switch

Switch Mode DIP Switch

Programming Button

Motor Select Button

Motor Select DIP Switch

Individual Switch

Push Terminals

Master Push

Terminals

Individual Switch RJ45 Ports

Master RJ45 Ports

TCP/IP Port

RS485 Port

PAGE 1
4 Channel Motor Controller Installation and Operating Instructions Product Details Product Description: 4 Channel Motor Controller Part Number: MT02-0401-331011 Connections and Indicators Master RJ45 Ports Individual Switch RJ45 Ports RS485 Port TCP/IP Port Motor Select DIP Switch Individual Switch Push Terminals Motor Select Button Programming Button Switch Mode DIP Switch Master Mode DIP Switch Master Push Terminals Power LEDs Motor LEDs Fuses AC Input AC Output Earth Rail Rod Initial Setup Before
PAGE 2
Wiring Instructions Set Keypad Group Control 1. Connect power and motors to the board. Only 1 motor per terminal. 2. When motors are properly wired and power is applied to the board, the POWER LED will illuminate solid green and the motors will move to their upper limit. Notes: If motors move to the lower limit, the wires are reversed. Disconnect power from the board and reverse the wires from the motor(s) moving in the wrong direction. NOTE: Motors must be stopped before setting keypad groups. 1.