Instruction manual

17
© 2010 Directed Electronics. All rights reserved.
controls on.
To perform Valet Take-Over:
1. Before turning off the engine, press and release
on the remote
control (or press and release the optional momentary switch). Then
wait five seconds.
2. Turn the ignition key to the OFF position. (The engine will stay run-
ning.) The engine will run until the pre-programmed time elapses
or a shut-down input is received. (See the previous Remote Start
section for a complete list of shut-down inputs.)
This feature will not work if the brake pedal is being pressed.
Power saver mode
Your system will automatically enter Power Saver Mode while armed/
locked or in Valet Mode, after a period of time in which no operation
has been performed.
To reduce power consumption the control center status LED modifies its
output if the vehicle is parked for an extended period. When Armed,
the flashing is reduced after 24 hours. When Valet mode is On, the
LED turns off after 1 hour and resets each time the ignition is turned off.