Installation guide

KKeeyy..

Turn the key to the ON position.

CChhoooossee..

Within 10 seconds, press and release the integrated LED/Valet

switch the number of times corresponding to the desired channel listed

below. Once you have selected the channel, press the switch once more

and HOLD it. The LED will flash and the horn will honk ( if connected)

to confirm the selected channel. Do not release the integrated LED/Valet

switch.

TTrraannssmmiitt..

While holding the integrated LED/Valet

switch, press the

button from the transmitter that you wish to assign to the selected

channel. The unit will chirp indicating successful programming. It is not

possible to teach a transmitter button to the system more than once.

RReelleeaassee..

Once the code is learned, the integrated LED/Valet

switch can

be released.

CChhaannnneellss ##44--66::

Channels 4 through 6 are used to assign the lock (arm), unlock (disarm) and panic

functions to separate buttons on the remote control. Teaching a button to Channel 4 erases all infor-

mation about that remote from memory. Any auxiliary functions that are desired will have to be

reprogrammed. Similarly, if the remote is set up to use the separate lock (arm), unlock (disarm) and

panic channels and a button from that remote is entered into channel one, the remote will be erased

from memory, and the system will only recognize the button that was entered into Channel 1.

Channel Number Function Wire Color

1 Lock (Arm)/Unlock (Disarm)/Panic

2 Silent Mode

/Remote Valet

/Trunk Release RED/WHITE

3 Remote Start or Other Accessory

4 Lock (Arm)/Panic

5 Unlock (Disarm) only

6 Panic only

7 Auto-learn Standard Configuration*

8 Auto-learn Single Button Lock (Arm)/Unlock (Disarm) Configuration*

9 Delete all transmitters

NNoottee::

For Auto Learn Configurations, see Transmitter Configurations section of this guide.

2003

Directed Electronics, Inc.