Installation guide

4. Release. The integrated LED/Valet
®
switch can now be released.
For example, to program the locking (arming) mode from active to passive, within 10 seconds of
turning the ignition off, press and release the integrated LED/Valet
®
switch once. Then press it again
and hold it. The LED will flash in groups of one and the horn will honk once (if connected). While
holding the integrated LED/Valet
®
switch, press the unlock button. The LED will stop flashing and
go out. The horn will honk twice if connected. Passive locking (arming) is now programmed. If that
was not the desired setting, without releasing the integrated LED/Valet
®
switch, press the lock
button. The LED will light solid and the horn will honk once if connected. Active locking (arming)
is now programmed. Release the integrated LED/Valet
®
switch after the selection has been made.
You can advance from feature to feature by pressing and releasing the integrated LED/Valet
®
switch
the number of times necessary to get from the feature you just programmed to the feature you wish
to access. For example, if you just programmed Feature 2 and you next want to program Feature 3
to off, release the integrated LED/Valet
®
switch. Press and release it once to advance from Feature 2
to Feature 3. Then press it once more and hold it. The LED will flash in groups of three and the
horn will honk three times (if connected) to confirm that you have accessed Feature 3.
The learn routine
TM
will be exited if:
➤ The ignition is turned on.
➤ The integrated LED/Valet
®
switch is pressed too many times.
➤ More than 15 seconds elapses between programming steps.
One long horn honk (if connected) indicates that the Learn Routine
TM
has been exited.
10
©
2003 Directed Electronics, Inc.