Instruction manual

Out of Range

Each time a command is performed the Responder LE will expect a

command conﬁrmation from the system. If a command conﬁrmation

is not received the transmit LED ﬂashes and a long fault tone plays as

an alert.

No Remote Output

Occasionally when a command is performed the remote may not

generate a command conﬁrmation output or Out of Range output.

This indicates that the system received the command but it was an

incomplete command (e.g. Aux button pressed too short to activate

the trunk release) or it was an illegal message (e.g. the command

was corrupted due to local RF interference). These are temporary nor-

mal functions of the system and remote, perform the command again

within 10 seconds to return to normal operation.

Feature not Available

The Feature Not Available output (transmit LED ﬂashing and long fault

tone) is a generic one which varies in cause and solution depending

upon the command used:

Command Cause Reason/Solution

Runtime Reset Remote Start is Off Only available when Remote Start is On

Sensor Bypass System is not armed Only available when system is armed