Instruction manual

7.0 STARTUP SM425 INSTRUCTION MANUAL
Note all settings will be reinitialized to default settings if the converter type selection is changed.
To confirm the converter type, follow these steps:
1. Press the setup key.
2. Use the▼ key to select Setup and press the [Enter] key.
3. Press the [Enter] key on the password entry display screen if a password has not been set for
commissioning. Otherwise enter the password for the Commissioning display screen. See
Section 1.50.5, “Setting Passwords” for information on setting a new password.
4. Select “Basic setup” and press the [Enter] key on the Commissioning display screen as shown in
Figure 7-8.
5. The Basic setup display screen shown in Figure 7-9 then appears. Confirm “This instrument is for
Oxygen” is displayed.
6. If the converter type is to be changed, press the [Enter] key. The display screen shown in Figure
7-10 appears.
7. Use the ▼ key to select the type of equipment. Then press the [Enter] key to complete the
converter selection.
Figure 7-8 Setup Display
Figure 7-9 Basic Setup
42500001 REV A 107