User`s manual

CD Automation srl REVO S User’s Manual
CD-Eng-REVO-S-1PH-60-210A-Solid-State-Relay
17
9 Input setting
The input type is already configured in line with customer requirements that are defined in the Order
Code. However, if you wish to change the input type (ex. from 0÷10V to 4÷20mA) set the jumpers as
below represented and then do the “Input calibration procedure”:
Important: The analog input isn’t isolated from Aux Supply. The series connection between
analogue inputs of the units is not possible.With AC Aux supply it's not possible connect the
zero terminal of Analogue Input to the earth. With DC Aux supply is not possible to connect
the zero of the power supply with the zero of analog input.
Warning: Before operate, be sure that power and control cables are isolated from voltage
sources