User`s manual

CD Automation srl REVO S User’s Manual
CD-Eng-REVO-S-1PH-60-210A-Solid-State-Relay
13
6.4 Power Terminals
Warning: Before connecting or disconnecting the unit check that power and control cables
are isolated from voltage sources.
Terminal Description
L1 Line Input Phase 1
T1 Load Output Phase 1
6.5 Command Terminals
Warning: Before connecting or disconnecting the unit check that power and control cables
are isolated from voltage sources.
6.5.1 SSR Input only terminal blocks M1
Terminal
M1
Description
1 Not connected
2 Not connected
3 Not connected
4 Not connected
5 Not connected
6 Not connected
7 - Input SSR
8 + Input SSR
6.5.2 Terminal block M1 for Analog Input or SSR input with HB
Terminal
M1
Description
1
Aux – Voltage Supply for elettronic boards 12-24V AC/DC
2
Aux – Voltage Supply for elettronic boards 12-24V AC/DC
3 - Cal Ext. 12/24Vdc
4 + Cal Ext. 12/24Vdc
5 C –Common contact relay alarm output (see HB Alarm contact for config.)
6 NC\NO –Normally Close\Open contact alarm relay output (see HB Alarm contact for config.)
7 - Control Input (SSR/0-10Vdc/4-20mA)
8 + Control Input (SSR/0-10Vdc/4-20mA)
6.6 Fan Supply (only from 120 to 210A)
Terminal
M2
Description
F1 Fan supply (230V standard – 115V option)
F2 Fan supply (230V standard – 115V option)