Specifications
CNC-210A Series Technical Manual
12
έᚊཝҋજ̼ѣࢨ̳Φ
TAILY AUTOMATION CO.,LTD.
6. PROGRAM UPDATE
The program version of CNC-210A can update through the
PC
1. Connect the
FLASH-A
and
RS-232
cable between
PC
and
CNC-210A
as below.
2. Put FLASH_A disk into the disk driver (You can also download from www.taily.com.tw),
click SETUP.EXE to install software, and then copy the XXXXX.TBN files to the hard disk
from TBN_FILE folder. (You can also download from www.taily.com.tw),
3. Click FLASH_A.EXE and follow the procedures below to update program version.
2
TLP-503D ID:011017
TLP-503D ID:011017
COM2
or
COM1
QD
ST.343!DBCMF):Q*
GMBTI.B
POWER VPP
TARGET
SOURCE
FLASH-A
MICRO CONTRO LLER
PC COM-PORT
TAILY
AUTO
TAILY AUTOMATION CO.,LTD .
έᚊཝҋજ̼ѣࢨ̳Φ
http//www.taily.com.tw
mail:taily@taily.c om.tw
TEL:886-2-29160387
FAX:886-2-29103525
Flash Memory Program ming
Adapter
MADE IN TAIWAN R.O.C.
CN4
PROGRAM UPDATE SOCKET
Update
procedures
1.
Click FILE icon to select file (XXXXX.TBN)
2.
Select COM-PORT from PORT list.
3.
Click OPEN icon to open the COM-PORT and make
UPDATE icon shone, ready to update
4.
Click UPDATE to start update.
5.When screen is complete shows
ok!
For four steps, it
means program update is finished, the CNC-210A
controller will reset automatically and the DATA
display shows the number of program version, then
get into READY mode.
6. Click EXIT to close the window, or
Click UPDATE for
another CNC-210A update.
Failure!! Message
:
◎
Phase 1-->Check File ..Failure !!
The program file is damaged. Please download the file from www.taily.com.tw
again.
◎
Phase 2-->Check Controller .. Failure !!
a. The program file is not suitable for CNC-210A, please confirm the program filename again.
b. Check the wire connection between
PC
and
CNC-210A
or
confirm the COM-PORT select is
correct.
◎
Phase 3-->Erase Flash memory .. Failure !!
Please send back the 210A-CPU board for repair.
◎
Phase 4-->Program Flash Memory Block.. Failure !!
Please send back the 210A-CPU board for repair.